International2cvFriends.com
http://www.international2cvfriends.com/forum/

AK 400 panels
http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=3315
Page 1 of 1

Author:  2CViking [ September 11th, 2011, 7:46 pm ]
Post subject:  AK 400 panels

Norman wrote:

John had bought the repair panels from SPOG and as there were no instructions provided, this was the only arrangement we could find in which they would fit.
There was no chance at all of it fitting as shown on Roy's picture.


It doesn't fit because the panel is the wrong size. It should be square which is what is in the ECAS picture and the original we removed. See picture showing original outlined in white.[/quote]



Attachment:
sIMG_1822.jpg


My turn to be in trouble. Just got these panels from SPOG but they just don't fit.
Thanks to Janez I'll fit his well made panel. http://2cvkeza.weebly.com/2cv-au---azu---ak.html

Attachment:
P9110228.JPG


Attachment:
P9110227.JPG

Author:  2CViking [ September 13th, 2011, 6:44 pm ]
Post subject:  Re: AK 400 panels

Had to cut the vertical face and weld it back together, allowing it to slide in between the chassis and cargo floor. Just be aware when ordering this repair panels when rebuilding the rear cross member.
Also slightly shorter than original but that doesn't matter much.

Couldn't use the panel from Janez, the AZU is not the same as AK (cargo floor and chassis is shorter)

Attachment:
P9120228.JPG


Attachment:
P9120229.JPG


Attachment:
P9120231.JPG


Attachment:
P9130233.JPG


Attachment:
P9130236.JPG


Attachment:
P9130237.JPG


Attachment:
P9130238.JPG

Page 1 of 1 All times are UTC + 1 hour [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/