Hi guys,
Just started so work on my 2cv and in need of a bit of advice
I need to replace the rear inner wings (or whats left of them), Whats the best way to do this? Im guessing I need to drill out spot welds but is it best to do this from underneath/wheel arch or try and get to them from above to minimise damage to rear sweep.
I will need to replace one sweep at some point but I'm abit afraid of removing to much at once.
I have bought replacement panels so far for:
rear light panel
boot floor and well
mid section panel where seat belts bolt down.
2 inner wings.
I may end also getting if I can find the ££
seat box
2 sweeps
Can anyone suggest the best order to do this in?
I have a large industrial spot welder so hoping to maximise use of this.
Sorry also is it best to keep the body on the chassis or to take it off?
Thanks
Mark
