what do i do with the push rod tubes, as the visa heads don't have them and are flat so wont fit?
April 18th, 2011, 3:07 pm
subarupete
Firing on two.
Joined: March 5th, 2009, 6:23 pm Posts: 2247 Location: Near Monmouth
Re: Visa pistons and barrels on a 602 block
Loius, The crankcase (halves) needs to be machined flat, IMO. What's happening about longer springs on Gertrude? Peter
April 18th, 2011, 3:50 pm
Sean
Firing on two.
Joined: April 22nd, 2009, 11:06 pm Posts: 3684 Location: Ecosse
Re: Visa pistons and barrels on a 602 block
you need visa heads if you want that, but you need to weld up and face the block where the push rod tubes seals seat. Or its 602 heads with barrels taken out to take the pistons.
_________________ Kissing the Lash "Any advice of a technical nature is given on the understanding that I've actually done this shit, not just read about it in D*lly club mag some time ago.
April 18th, 2011, 3:57 pm
Little Louis
Field Plougher
Joined: February 8th, 2009, 12:07 am Posts: 2357
Re: Visa pistons and barrels on a 602 block
I've got all the pistons and barrels ect.. I'll find out about getting it sorted.
@ scooby pete my dad still wants them he keeps on about it, ring him up and remind him to do something about it
Users browsing this forum: No registered users and 37 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
