oo err... we've gotta do these on Lily before she starts a stream of oil down the road
we're getting ours from gsf - seenas they supply ecas it will be the same as the ones on ecas
is it a hard job todo? what has to come off?
| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| Push rod seals http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=274 |
Page 1 of 1 |
| Author: | Jono [ April 14th, 2009, 6:53 pm ] |
| Post subject: | Push rod seals |
The ones with the sticky-out eyelids on them - are they any good/which way around do they go on an M28 engine? You'd assume that the eyelid bit goes to the bottom, but that actually looks like it's the wrong way round when compared to the original flat-faced seals. I've never used this type before, and I'm not sure where we got them from, they were just in the bag of new bits in the garage. Many thanks. |
|
| Author: | JRW_91 [ April 15th, 2009, 1:45 pm ] |
| Post subject: | Re: Push rod seals |
oo err... we've gotta do these on Lily before she starts a stream of oil down the road we're getting ours from gsf - seenas they supply ecas it will be the same as the ones on ecas is it a hard job todo? what has to come off? |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|