Joined: December 8th, 2008, 5:58 pm Posts: 1404 Location: Near Matlock, Derbyshire
Push rod seals
The ones with the sticky-out eyelids on them - are they any good/which way around do they go on an M28 engine? You'd assume that the eyelid bit goes to the bottom, but that actually looks like it's the wrong way round when compared to the original flat-faced seals.
I've never used this type before, and I'm not sure where we got them from, they were just in the bag of new bits in the garage.
Many thanks.
April 14th, 2009, 6:53 pm
JRW_91
lovin' the snatch
Joined: January 27th, 2009, 8:10 pm Posts: 1289 Location: Northampton
Re: Push rod seals
oo err... we've gotta do these on Lily before she starts a stream of oil down the road
we're getting ours from gsf - seenas they supply ecas it will be the same as the ones on ecas
is it a hard job todo? what has to come off?
_________________ |-|-' 602 For Life
Keep Them Looking Standard.
1979 Myosotis Blue Dyane6 1986 Sunrise Red 2cv6 1989 Vert Bamboo 2cv6 D*lly (in bits)
Users browsing this forum: No registered users and 125 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
