International2cvFriends.com
http://www.international2cvfriends.com/forum/

Wiper Motor rubber bushes
http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=2602		 Page 1 of 2
Author:  Rumble602 [ January 15th, 2011, 2:40 pm ]
Post subject:  Wiper Motor rubber bushes
Are the rubber bushes that are used with the bolts that hold the wiper motor to the spindle assembly available from anywhere?
Mine are getting pretty badly perished and could do with replacing.

Cheers,

Aidan
Author:  Sean [ January 15th, 2011, 4:40 pm ]
Post subject:  Re: Wiper Motor rubber bushes
maplins and the like- grommits, panel mounts etc?
Author:  spanners [ January 15th, 2011, 6:58 pm ]
Post subject:  Re: Wiper Motor rubber bushes
I may be way off the mark but, I have a feeling (and I'm ready to be proven very wrong) that they're very similar to the gear lever bushes if not possibly the same?
Author:  Rumble602 [ January 17th, 2011, 8:24 pm ]
Post subject:  Re: Wiper Motor rubber bushes
I was thought the same when I was looking at them. Through panel grommets. There's an idea.
Author:  Sean [ January 18th, 2011, 12:19 pm ]
Post subject:  Re: Wiper Motor rubber bushes
spanners wrote:
I may be way off the mark but, I have a feeling (and I'm ready to be proven very wrong) that they're very similar to the gear lever bushes if not possibly the same?


Hmm think you may be right had a moment when i was rummaging through the "box of assorted rubbery crap" looking for a gear change grommet...

will see if old wiper motor turns up today - last push to get the "d0lly from hell" out so i can get on with mine and then The Orange one

as well as dyane inlet pipe
dyane spline wipers
and some interior light lenses.....all of which ive promised to people :oops:

on the good side of all this lockup rummaging found set of square lights, 4 spare shells and 1 spare reflector-happy days
Sean
Author:  Sean [ January 18th, 2011, 1:19 pm ]
Post subject:  Re: Wiper Motor rubber bushes
Ok gear rubbers too big. Grommets in halfords look a better bet something M5 M6 size
Author:  Rumble602 [ January 18th, 2011, 8:13 pm ]
Post subject:  Re: Wiper Motor rubber bushes
Cheers for that Sean - if anyone can confirm the bolt size I'll get myself some grommets sorted out.
Author:  spanners [ January 23rd, 2011, 6:23 pm ]
Post subject:  Re: Wiper Motor rubber bushes
I looked into this earlier and stripped them off an old wiper motor I had lying around-I can confirm that they are actually gear linkage bushes but they have wee metal sleeves in them.

Image
Author:  Sean [ January 23rd, 2011, 8:01 pm ]
Post subject:  Re: Wiper Motor rubber bushes
the one i poked about with last week werent - much thinner but couldnt see any sleeve- hey ho nothings simple-very little is original
Author:  Russell [ January 23rd, 2011, 8:12 pm ]
Post subject:  Re: Wiper Motor rubber bushes
Give me the size and I'll look at work, we carry a few grommets in stock.
Page 1 of 2 All times are UTC + 1 hour [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/