| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| AMI 6 window rubber http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=2358 |
Page 1 of 1 |
| Author: | EirikJ [ October 26th, 2010, 12:28 am ] |
| Post subject: | AMI 6 window rubber |
Hi folks. Was wondering if there is s(l)ide window rubber for an AMI 6 available somewhere?! Reproduction or something? |
|
| Author: | 2CViking [ October 26th, 2010, 9:57 am ] |
| Post subject: | Re: AMI 6 window rubber |
Try this mob http://www.woolies-trim.co.uk/c-310-double-track.aspx |
|
| Author: | lpgo [ October 26th, 2010, 12:18 pm ] |
| Post subject: | Re: AMI 6 window rubber |
The Dutch "amivereniging" got them too but I don't now prices. http://www.amivereniging.nl/ |
|
| Author: | Willami [ October 26th, 2010, 4:26 pm ] |
| Post subject: | Re: AMI 6 window rubber |
Hi there I replaced mine using the 22mm channel in this link, it works well - doesn't slide about or lift / bend when opening the windows but do note that i had to drill holes / slots through the rubber to meet up with the drain slots in the door top - fairly easy, craft knife and very sharp drill bit. depending on what rivets you use - you may find that standard rivets (to hold the internal chrome strip on) tend to squash the channel in a few places, but not so much to stop the glass sliding past. however, I believe John Sobey may have used an alternative to this - possibly from an English classic stockist? you would have to ask.....also heard that some Landrover channel can do the job.... That's everything I learnt when I did mine.... door tops are so vunerable on these Amis!!!! good luck Will 2CViking wrote: |
|
| Author: | EirikJ [ October 26th, 2010, 7:20 pm ] |
| Post subject: | Re: AMI 6 window rubber |
Thanks a lot guys. By the way, discussed in some other thread, about using a rear door from a sedan on a Break. Just replaced my left rear door on my break with the spare-door from a sedan. Fitted like a glove. Had to dismount the window-frames of course, as they are not the same. (This is only possible on AMI 6's before October(I think) 1968, who has the bolted on aluminum window frames) |
|
| Author: | Willami [ October 27th, 2010, 2:49 pm ] |
| Post subject: | Re: AMI 6 window rubber |
EirikJ wrote: Thanks a lot guys. By the way, discussed in some other thread, about using a rear door from a sedan on a Break. Just replaced my left rear door on my break with the spare-door from a sedan. Fitted like a glove. Had to dismount the window-frames of course, as they are not the same. (This is only possible on AMI 6's before October(I think) 1968, who has the bolted on aluminum window frames) thanks Eirik - interesting, I will try mine again.... |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|