I would think so... maybe heat it with a hair dryer or stripping gun to avoid any paint damage. obviously take the grille off...
| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| Bent panels http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=144 |
Page 1 of 1 |
| Author: | samfieldhouse [ February 24th, 2009, 10:26 am ] |
| Post subject: | Bent panels |
Ok, so somebody's rear bumper impacted with my bonnet and now theres a nice dent about 8" across to the right of the grill. The metal isn't creased, will it pop out with some help? |
|
| Author: | Tim2cv [ February 24th, 2009, 10:39 am ] |
| Post subject: | Re: Bent panels |
I would think so... maybe heat it with a hair dryer or stripping gun to avoid any paint damage. obviously take the grille off...
|
|
| Author: | samfieldhouse [ February 24th, 2009, 10:52 am ] |
| Post subject: | Re: Bent panels |
I'll give it a go, mind need to re-spray the area anyway sadly. Shame as the bonnet was in good nick |
|
| Author: | Louis [ March 3rd, 2009, 11:32 pm ] |
| Post subject: | Re: Bent panels |
When you bang it out Make sure you have something like a thick leather glove or a good thick cotton pad before u belt it. This will Spread the shock Help to preserve the paint and will hopefully allow the dent to be softly knocked out Best way i normally do it is to use the palm of me hand with the pad.. Normally very good results |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|