| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| 2cv dimensions http://www.international2cvfriends.com/forum/viewtopic.php?f=7&t=1099 |
Page 1 of 1 |
| Author: | Simon Crook [ December 7th, 2009, 10:34 pm ] |
| Post subject: | 2cv dimensions |
Anyone got a Haynes manual to hand, I am looking for the following dimensions... Front track (wheel centre to wheel centre) mm Rear track (same as above) mm Front to Rear wheel centers mm thanks |
|
| Author: | Sean [ December 7th, 2009, 10:39 pm ] |
| Post subject: | Re: 2cv dimensions |
Simon Crook wrote: Anyone got a Haynes manual to hand, I am looking for the following dimensions... Front track (wheel centre to wheel centre) mm Rear track (same as above) mm Front to Rear wheel centers mm thanks in order... 1260mm same 2400mm Sean |
|
| Author: | hjbharry [ December 7th, 2009, 11:00 pm ] |
| Post subject: | Re: 2cv dimensions |
Does the front-rear measurement not change when you lower/raise thee car? |
|
| Author: | Simon Crook [ December 7th, 2009, 11:23 pm ] |
| Post subject: | Re: 2cv dimensions |
thanks Sean, and Harry you are right I'm sure, but for the mo thats a good start cheers |
|
| Author: | Jonathan [ December 7th, 2009, 11:52 pm ] |
| Post subject: | Re: 2cv dimensions |
As the car loads up, the suspension lowers and the wheelbase does indeed increase. Apparently, with four passengers and their luggage(whatever that means  )the car's wheelbase increases by 2inches, but the steering geometry also changes, the castor angle increases by 8 degrees, so neutralising any adverse influence the added weight might have on handling and road-holding 
|
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|