|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
2CViking
viking bastard
Joined: April 18th, 2009, 11:43 am
Posts: 2424
Location: Meneac, Bretagne France
|
 Gear lever tube bushes A real pain in the rear to replace. Heard that someone in the UK is replacing these bushes without any hassles. I’ve done a few using several methods but the only one I can manage without destroying the bush is to cut the lever in two. The lever slides out giving plenty of room to replace both bushes and then weld the lever back together again. Maybe not ideal but very easy. Any other ideas?
You do not have the required permissions to view the files attached to this post.
_________________
|
| May 7th, 2009, 10:10 am |
 
|
|
|
Russell
Firing on two.
Joined: November 29th, 2008, 10:05 pm
Posts: 9259
Location: West Sussex, U.K.
|
Re: Gear lever tube bushes Yes, there's a fella not far from me who does this, I'll get in touch!
_________________
samfieldhouse wrote: What I like about I2F is that there is no pretence of democracy.
|
| May 7th, 2009, 9:41 pm |
|
|
|
2CViking
viking bastard
Joined: April 18th, 2009, 11:43 am
Posts: 2424
Location: Meneac, Bretagne France
|
Re: Gear lever tube bushes Thanks mate. look forward to it.
_________________
|
| May 7th, 2009, 10:40 pm |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 42 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
