|
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
| Author |
Message |
|
Edce
Firing on two.
Joined: October 12th, 2019, 6:40 pm
Posts: 164
Location: Limburg Belgium
|
 Oil pressure I am curious about the level of oil pressure we can expect in the 2cv engines (602 and 652 cc). I have installed an oil pressure reading gauge. At idle I measure 20 psi (1,2 bar) and at around 4000 rpm, it is 60 psi (4,4 bar). Anybody has same experience ?
|
| June 12th, 2020, 6:10 pm |
|
|
|
subarupete
Firing on two.
Joined: March 5th, 2009, 6:23 pm
Posts: 2245
Location: Near Monmouth
|
Re: Oil pressure From https://www.citroenspecialsclub.org/pub ... /page1.phpAfter starting the car and left to warm up to a steady idle the readings were 115 psi at 6000 rpm 90 psi at 3000 and 50 psi at 1000 I then went on a blast for 1/2 hour reaching 60ish mph. After this the readings were 90 psi at 6000 rpm 60 psi at 3000 rpm, at idle the reading was 20 psi dropping to 15 psi after a couple of minutes.
|
| June 12th, 2020, 7:26 pm |
|
|
|
Taskos
Firing on two.
Joined: February 22nd, 2012, 10:34 am
Posts: 418
Location: Greece
|
Re: Oil pressure According to Haynes manual:
A79/0 and M4 35.5 to 44 lbf/in2 @4000rpm
A79/1 57 to 71 lbf/in2 @6000rpm
M28 and m28/1 78 to 92 lbf/in2 @6000rpm
_________________
I've Been Wrong Before.
|
| June 16th, 2020, 10:02 pm |
|
|
|
Edce
Firing on two.
Joined: October 12th, 2019, 6:40 pm
Posts: 164
Location: Limburg Belgium
|
Re: Oil pressure Thnks Taskos, I have a Visa engine but the values seem to be similar.
|
| June 17th, 2020, 8:50 am |
|
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 104 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
