International2cvFriends.com
http://www.international2cvfriends.com/forum/

World meeting 2019
http://www.international2cvfriends.com/forum/viewtopic.php?f=6&t=6149
Page 2 of 2

Author:  Roger V [ August 8th, 2018, 5:11 pm ]
Post subject:  Re: World meeting 2019

Are you sure it is fully in 1st gear? What condition are the rubber grommets on the linkage? Under normal driving without the trailer, is 1st gear noisy at all?

Author:  mobylette69 [ August 8th, 2018, 6:08 pm ]
Post subject:  Re: World meeting 2019

Yes linkages look fine..1st gear doesnt sound any noise than usual...Im not sure if there is a thrust bearing issue as there is whine or rattle when I engage clutch

Author:  AZL57 [ August 8th, 2018, 8:06 pm ]
Post subject:  Re: World meeting 2019

Are the motor and gearbox support rubbers ok?

Author:  mobylette69 [ August 8th, 2018, 8:25 pm ]
Post subject:  Re: World meeting 2019

They all look fine, in normal use it never has popped out of gear...maybe it just wasn't in correctly ??

Author:  EirikJ [ August 9th, 2018, 9:47 am ]
Post subject:  Re: World meeting 2019

Make sure the gearlever doesn't touch anything in the engine compartment when in 1st gear. Or any other gear for that matter....

Author:  AZL57 [ August 13th, 2018, 5:13 pm ]
Post subject:  Re: World meeting 2019

The edge of the fire wall is dented in the 2cv i don't know if that if the dyane is also.

Author:  samfieldhouse [ August 22nd, 2018, 10:11 am ]
Post subject:  Re: World meeting 2019

AZL57 wrote:
The edge of the fire wall is dented in the 2cv i don't know if that if the dyane is also.


I thought that was only early 602s

Page 2 of 2 All times are UTC + 1 hour [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/