View unanswered posts | View active topics It is currently March 29th, 2024, 1:52 am



Reply to topic  [ 339 posts ]  Go to page Previous  1 ... 26, 27, 28, 29, 30, 31, 32 ... 34  Next
 Yellow Dyane 
Author Message
Firing on two.
User avatar

Joined: March 21st, 2013, 12:04 am
Posts: 1577
Location: Exeter, Devon
Post Re: Yellow Dyane
I have same setup on the Shed, and it looks ok :)

_________________
If you can't fix it with a hammer, it's probably electrical (or, an electric fuel pump!) ....


June 2nd, 2022, 9:15 pm
Profile
Firing on two.

Joined: December 21st, 2014, 7:33 pm
Posts: 866
Location: Rhayader Mid Wales
Post Re: Yellow Dyane
ImageP1030761 by Robndaisy, on Flickr

I used the old air filter to carb hose which,with some persuasion, I managed to fit without too much swearing ;) . Just need to trim the end of the hoseclip.



AZL57 wrote:
Very nice. Are you able to put the hose between the cowling an the filter? Looks like there it's a bit to close??


June 3rd, 2022, 12:32 pm
Profile
Firing on two.

Joined: December 21st, 2014, 7:33 pm
Posts: 866
Location: Rhayader Mid Wales
Post Re: Yellow Dyane
I still need to paint the bracket that holds the throttle spring :D .

Roger V wrote:
I have same setup on the Shed, and it looks ok :)


June 3rd, 2022, 12:33 pm
Profile
Firing on two.

Joined: December 21st, 2014, 7:33 pm
Posts: 866
Location: Rhayader Mid Wales
Post Re: Yellow Dyane
This late Dyane has plastic headlamp bowls, there are nuts set into the back of it, rusty nuts that would never unscrew without turning in the moulding. I cut off the heads with a slitting disc and then punched out the nuts when the unit was on the bench.

ImageP1030746 by Robndaisy, on Flickr

The headlamp clicks into three plastic/nylon? sockets and adjustment is by moving the ballscrews fastened to the lamp in and out for alignment. one of the sockets is connected by a long cable to the control knob in the cabin that sets the lights depending on how loaded the car is.
The cables are seized just at the ends where they meet the headlamp bowl, I might see if I can shorten them, otherwise it's new ones I guess.


ImageP1030747 by Robndaisy, on Flickr

ImageP1030754 by Robndaisy, on Flickr

ImageP1030748 by Robndaisy, on Flickr

As you can see, it's lost one of it's lugs and the rusty cable end has bailed out.
It's got to be replaced and luckily, repro kits are available.
It's spring loaded and happy where it is.

ImageP1030755 by Robndaisy, on Flickr

I pushed it back,

ImageP1030756 by Robndaisy, on Flickr

ImageP1030757 by Robndaisy, on Flickr

got the cutters on it and cut it. The spring shot out but I managed to find it, a minor miracle in this mess of a shed :lol: .

ImageP1030758 by Robndaisy, on Flickr

ImageP1030753 by Robndaisy, on Flickr

ImageP1030751 by Robndaisy, on Flickr

The fixed sockets that were broken I drilled a 5mm. hole in them a little way and punched them out.


June 3rd, 2022, 1:45 pm
Profile
Firing on two.
User avatar

Joined: October 22nd, 2014, 10:59 pm
Posts: 1994
Location: South-Limburg
Post Re: Yellow Dyane
Nice job...


June 3rd, 2022, 8:21 pm
Profile
Firing on two.
User avatar

Joined: February 22nd, 2012, 10:34 am
Posts: 412
Location: Greece
Post Re: Yellow Dyane
I salute your relentless efforts.
A great encouragement to us all.

_________________
I've Been Wrong Before.


June 3rd, 2022, 9:54 pm
Profile
Firing on two.

Joined: December 21st, 2014, 7:33 pm
Posts: 866
Location: Rhayader Mid Wales
Post Re: Yellow Dyane
ImageP1030762 by Robndaisy, on Flickr

The left wing had battery acid corrosion and was very thin.

ImageP1030765 by Robndaisy, on Flickr

Managed to stitch it, better than fresh air.

ImageP1030769 by Robndaisy, on Flickr

Rough but the seam sealer will help.

ImageP1030766 by Robndaisy, on Flickr

Yes I've still got the paint that I used on the van.

ImageP1030773 by Robndaisy, on Flickr

That's just about the distance so it looks ok ;) .
Ford Rio Brown is a passable colour. The inner wings are factory primered brown and I guess that's how they were? :?:


June 19th, 2022, 9:33 pm
Profile
Firing on two.

Joined: December 21st, 2014, 7:33 pm
Posts: 866
Location: Rhayader Mid Wales
Post Re: Yellow Dyane
I went over to ECAS and picked up tyres, rims headlights etc. and also the cables to move the lamps when the car is loaded.

ImageP1030778 by Robndaisy, on Flickr

This is to support the new sliding socket as I press the end of the cable home, don't want to mess up now.

ImageP1030776 by Robndaisy, on Flickr

It went in after I'd made the crimped end acceptable ;)
I get that the Dyane is a better car but there are things that compared to the brutal simplicity of earlier A series, are just more opportunities to rust or break. Still the flamer is 40 years old and nearly done :)


June 27th, 2022, 7:40 pm
Profile
Firing on two.
User avatar

Joined: March 5th, 2009, 6:23 pm
Posts: 2130
Location: Near Monmouth
Post Re: Yellow Dyane
Hats off the your ingenuity and tenacity.


June 27th, 2022, 9:35 pm
Profile
Firing on two.

Joined: December 21st, 2014, 7:33 pm
Posts: 866
Location: Rhayader Mid Wales
Post Re: Yellow Dyane
Thanks Pete, I've project fatigue big time now though, I just want the flamer all together and back on the road.
I think it's a combination of working 5 days 'cos my boss left and we've been unable to find a suitable replacement and a general sense of old age catching up with me :lol: .


June 28th, 2022, 8:22 am
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 339 posts ]  Go to page Previous  1 ... 26, 27, 28, 29, 30, 31, 32 ... 34  Next

Who is online

Users browsing this forum: No registered users and 108 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.
Designed by STSoftware for PTF.