International2cvFriends.com
http://www.international2cvfriends.com/forum/

My Beduino
http://www.international2cvfriends.com/forum/viewtopic.php?f=5&t=6044
Page 29 of 34

Author:  AZL57 [ January 11th, 2021, 6:05 pm ]
Post subject:  Re: My Beduino

Yes 2cv is stronger, dyane is faster.

Author:  subarupete [ January 11th, 2021, 8:03 pm ]
Post subject:  Re: My Beduino

For a 4x4 need a 2off - Diff 8/33 - 4.125 (some early Dyanes)
Any offers

Author:  Roger V [ January 11th, 2021, 8:20 pm ]
Post subject:  Re: My Beduino

Will you have the hp to turn all that gearing and raise the ratio!

Kevin (@notsmartcar @Newton Abbot) perhaps. Or on Facebook Simon Sobey (Dursley, Gloucester) if he has some drummers left.

Author:  Roger V [ April 5th, 2021, 6:30 pm ]
Post subject:  Re: My Beduino

bored today and cold outside ...... again ......

So I'm having a play with the Breather clamp.

I'm going to print one and see how it holds up. :)


It won't be different colours ..... :)

Attachments:
Breather Clamp.png
Breather Clamp.png [ 70.04 KiB | Viewed 10902 times ]

Author:  Ianredspecial [ April 8th, 2021, 3:02 pm ]
Post subject:  Re: My Beduino

So pretty. Hehe.

Author:  Roger V [ May 4th, 2021, 10:07 pm ]
Post subject:  Re: My Beduino

I wanted to raise the seats I have in the Shed. I've been meaning to since I bought them a few years ago.

I have some 50mm box section mild steel that I appear to have started cutting to length previously!

So, to finish cutting, I bought some new hacksaw blades ..... At 5mm thick steel, I so wish I bought some angle grinder blades :roll: :lol: :lol: :lol:

Author:  Roger V [ January 16th, 2023, 11:53 pm ]
Post subject:  Re: My Beduino

Not posted on my own topic for a while! :D

Have found a garage to rent for a while so can I dry the Shed out.

Roof, and the windscreen seal is leaking a lot. :( Floor needs welding :(

Author:  Ianredspecial [ January 17th, 2023, 11:33 am ]
Post subject:  Re: My Beduino

Best thing I ever did was drill a couple holes in the floor! Just wish I'd done it sooner.

Author:  Roger V [ February 22nd, 2023, 7:50 pm ]
Post subject:  Re: My Beduino

Sent off for a circuit board today. Not holding my breath it will work :lol:

Attachments:
2+2 Channel STM32F11 Core.png
2+2 Channel STM32F11 Core.png [ 217.12 KiB | Viewed 8140 times ]

Author:  AZL57 [ February 22nd, 2023, 9:28 pm ]
Post subject:  Re: My Beduino

Yes it is easier to drill holes than to weld them up ;-)

Page 29 of 34 All times are UTC + 1 hour [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/