International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
My Beduino http://www.international2cvfriends.com/forum/viewtopic.php?f=5&t=6044 |
Page 27 of 34 |
Author: | subarupete [ September 25th, 2020, 12:23 pm ] |
Post subject: | Re: My Beduino |
Your 3D printer was a solution waiting for problems. Keep up the good work |
Author: | lpgo [ September 25th, 2020, 5:15 pm ] |
Post subject: | Re: My Beduino |
subarupete wrote: Your 3D printer was a solution waiting for problems. Hilarious.. |
Author: | Roger V [ September 26th, 2020, 11:06 pm ] |
Post subject: | Re: My Beduino |
Trying to get the temperature up on the reducer as much as possible, so added some jubilee clips to the copper coil in the exhaust. Clamped one end, and turned the coil to tighten it against the exhaust pipe, and clamped other end with the clip. The clamps will also stop the coil chattering against the exhaust pipe. |
Author: | Roger V [ November 6th, 2020, 7:52 pm ] |
Post subject: | Re: My Beduino |
I have the Shed running in LPG. However, I'm trying to add another sensor to the firmware, and its doing my nuts in! |
Author: | AZL57 [ November 7th, 2020, 8:30 pm ] |
Post subject: | Re: My Beduino |
It's autumn you should have nuts around this time of year... |
Author: | Roger V [ November 7th, 2020, 11:07 pm ] |
Post subject: | Re: My Beduino |
@azl57 Plenty of nuts about, but i have get it done before i go back to the institution, as they are not much help! |
Author: | Roger V [ November 8th, 2020, 10:19 am ] |
Post subject: | Re: My Beduino |
Fuel Temp Sensor added to software. woo woo Now to move the Inlet Air Temperature sensor as its getting heat sink with the Dyane airbox being over the exhaust. Its been starting on lpg now as well, after a few cranks. Still needs tweaking though. Once it starts reliably on lpg, i will see about adding the fuel pump to the petrol side. |
Author: | Roger V [ November 11th, 2020, 6:46 pm ] |
Post subject: | Re: My Beduino |
Moved iat sensor to rubber connector between air filter box and carb. Much more sensible readings at idle now. I think where the sensor was mounted on the filter box, stopped air passing it at low rpm. But that part of the box was being heated by the exhaust, causing heat soak to the sensor. That in turn caused the ECU to pull fuel and weaken the mixture. Needs a run and log to confirm. And probably retune. |
Author: | Edce [ November 11th, 2020, 8:49 pm ] |
Post subject: | Re: My Beduino |
Quite an improvement I am sure !!! |
Page 27 of 34 | All times are UTC + 1 hour [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |