Well, that shows its not to uncommon. I'll try making my own. Always seem To have an issue with the exhaust manifold blowing, so thought it may be more resilient.
| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| My Beduino http://www.international2cvfriends.com/forum/viewtopic.php?f=5&t=6044 |
Page 21 of 34 |
| Author: | AZL57 [ January 11th, 2020, 6:15 pm ] |
| Post subject: | Re: My Beduino |
there is a firm in the us that makes copper head gaskets on measure. |
|
| Author: | Roger V [ January 11th, 2020, 9:26 pm ] |
| Post subject: | Re: My Beduino |
Well, that shows its not to uncommon. I'll try making my own. Always seem To have an issue with the exhaust manifold blowing, so thought it may be more resilient.
|
|
| Author: | Ianredspecial [ January 12th, 2020, 11:30 pm ] |
| Post subject: | Re: My Beduino |
Ecas do a copper one. I used it but it didn't do any good for my endlessly blowing manifold. Timeserts were the way forward for me. Not put in by me, crucially.... |
|
| Author: | Roger V [ January 12th, 2020, 11:48 pm ] |
| Post subject: | Re: My Beduino |
Ian I dont recall ecas doing a copper exhaust gasket! They do a 'carbon fibre' gasket, or copper plated nuts, but cant see a copper gasket.
|
|
| Author: | Ianredspecial [ January 13th, 2020, 2:05 am ] |
| Post subject: | Re: My Beduino |
Pretty sure I got them from there, by ringing Roy. |
|
| Author: | Roger V [ January 14th, 2020, 11:41 pm ] |
| Post subject: | Re: My Beduino |
Thanks Ian, I'll bear that in mind.
|
|
| Author: | Roger V [ January 19th, 2020, 5:55 pm ] |
| Post subject: | Re: My Beduino |
I've installed the MAP pipe over the last few days. The sensor is on the ECU, and there is a pipe to the manifold. MAP at idle is hovering around 55 kpa which is quite high. |
|
| Author: | lpgo [ January 20th, 2020, 1:16 pm ] |
| Post subject: | Re: My Beduino |
Roger V wrote: I've installed the MAP pipe over the last few days. The sensor is on the ECU, and there is a pipe to the manifold. MAP at idle is hovering around 55 kpa which is quite high. Do you have the right sensor configered in the software??? Is it around 100 when the engine doesn,t run.. (100 is the airpressure).. |
|
| Author: | Roger V [ January 20th, 2020, 8:31 pm ] |
| Post subject: | Re: My Beduino |
Hi Geo Yes, I'm sure its correctly configured. What MAP do you get at idle? That will give me a target to aim for. Edit There is a different sensor in the drop down list. I will try it tomorrow.
|
|
| Author: | Lars E [ January 22nd, 2020, 5:27 pm ] |
| Post subject: | Re: My Beduino |
My 2cv whit Mega Squirt i about 50 kpa at idle |
|
| Page 21 of 34 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|