| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| Van repairs http://www.international2cvfriends.com/forum/viewtopic.php?f=5&t=5707 |
Page 1 of 78 |
| Author: | rob massey55 [ September 1st, 2015, 10:15 am ] |
| Post subject: | Van repairs |
Morning all, I'm working on the cargo floor area, fitting a new valence panel  IMG_3078 by Robndaisy, on FlickrI bolted it to the chassis rails but it was sitting too low about 25mm  IMG_3083 by Robndaisy, on Flickrso I packed it up with some square tube so now it's level with the floor but it is fouling the bottom of the chassis rails if you see what I mean! Has anyone got a pic of how it should fit? Cheers, rob. |
|
| Author: | Geert [ September 1st, 2015, 12:03 pm ] |
| Post subject: | Re: Van repairs |
there is something wrong there , but I can't see what it is. It should fit perfectly . |
|
| Author: | rob massey55 [ September 1st, 2015, 6:13 pm ] |
| Post subject: | Re: Van repairs |
Cheers Geert, I went looking for the old valence, what's left of it!  IMG_3092 by Robndaisy, on FlickrNow I see the difference! I'll have to modify 
|
|
| Author: | Geert [ September 1st, 2015, 6:18 pm ] |
| Post subject: | Re: Van repairs |
It is too low, You should order one from 2CV KEZA, I think ECAS sells them in the UK. They should fit 100 % ! |
|
| Author: | rob massey55 [ September 1st, 2015, 7:29 pm ] |
| Post subject: | Re: Van repairs |
Yeah, it came from UK, I must have ordered the wrong one! |
|
| Author: | Roy Eastwood [ September 2nd, 2015, 12:45 pm ] |
| Post subject: | Re: Van repairs |
This is the correct part: http://www.ecas2cvparts.co.uk/rear-floor-rear-fascia-crossmember-p-2066.html |
|
| Author: | 2CViking [ September 2nd, 2015, 12:55 pm ] |
| Post subject: | Re: Van repairs |
Isn't AZU lower than AK, since the AZU is shorter (cross bar further forward) |
|
| Author: | rob massey55 [ September 2nd, 2015, 6:51 pm ] |
| Post subject: | Re: Van repairs |
Roy Eastwood wrote: This is the correct part: http://www.ecas2cvparts.co.uk/rear-floor-rear-fascia-crossmember-p-2066.html Cheers Roy, I ordered the wrong bit. http://www.ecas2cvparts.co.uk/rear-lowe ... -1693.html I'll have to order the right part after next payday. |
|
| Author: | 2cvkeza [ September 3rd, 2015, 11:00 am ] | ||
| Post subject: | Re: Van repairs | ||
Peter... AZU has shorter chassis so back crossmember is higher than AK...
|
|||
| Author: | 2cvkeza [ September 3rd, 2015, 11:16 am ] | ||
| Post subject: | Re: Van repairs | ||
rob massey55 ... I just looked at your van pictures there at Flickr... "crist" ... looks like big job at that AZU ...  For cars like this I produce and assembly complete back bed ... It is AK350 on photo but I do assembly AZU, 250 and Acadiane sets as well... Ask Roy ECAS for some more AZU panels... like 2. and 3. crossmember, side B post panels and inner wings. It will be easyer for you to rebuild this AZU completly with my panels...
|
|||
| Page 1 of 78 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|