International2cvFriends.com
http://www.international2cvfriends.com/forum/

Cloverleaf 1925
http://www.international2cvfriends.com/forum/viewtopic.php?f=5&t=5452		 Page 6 of 6
Author:  AZL57 [ January 26th, 2022, 10:53 pm ]
Post subject:  Re: �Cloverleaf 1925
Now had another wood job. But on that same door. The T-profile that goes around the edge. It turned out that it wasn't a straight T but the vertical part was at an angle. It turned out i forgot that i saved the old door and did see the sides of that were cut out to fit that T-profile in. So now i had to cut that angle around the door. Then i have to form the profile to fit the door. A lot of work. But it is fitted now after 3 evenings. To complicate the matter the door is curved in 3 directions.

Attachments:
deur2a.jpg
deur2a.jpg [ 75.05 KiB | Viewed 6085 times ]
deur1.jpg
deur1.jpg [ 147.47 KiB | Viewed 6085 times ]
Author:  AZL57 [ February 5th, 2022, 5:53 pm ]
Post subject:  Re: �Cloverleaf 1925
Well the door fits the opening in the car's body. But it seem it has a slight different curve than the body. I have to check with a good lamp to see if it touches somewere. Door catch and hinges stille have to put in.

The door fits well now after i did remove some wood of the edge. The door catch still has has to be put in, as you can see i have to remove some metal as the lock is lower than the place reserved in the body.

Attachments:
d310.jpg
d310.jpg [ 468.66 KiB | Viewed 5925 times ]
d110.jpg
d110.jpg [ 316.48 KiB | Viewed 5925 times ]
Page 6 of 6 All times are UTC + 1 hour [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/