| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| Dyane by White http://www.international2cvfriends.com/forum/viewtopic.php?f=5&t=5408 |
Page 1 of 3 |
| Author: | White 2cv [ September 29th, 2014, 10:35 pm ] |
| Post subject: | Dyane by White |
Hallo I am new here, but not new in A series. I had a lot Dyanes in my life, but now I have 2. Original Cimos Dyane 1980 an one from all whether, which one is in progress of restoration.... But one picture is for 1000 words....give em advantage. Me and my third Dyane in 2001.  Now  In process..  
|
|
| Author: | lpgo [ September 29th, 2014, 11:51 pm ] |
| Post subject: | Re: Dyane by White |
Great cars.... whats the painting on the bonnet all about???? |
|
| Author: | White 2cv [ September 30th, 2014, 11:22 pm ] |
| Post subject: | Re: Dyane by White |
The painting was on the car,when I bought car in 2006. Previous owner used car for promotion his pub in late nineties. On the doors he painted camels and Bedouin, when ride in Sahara. On bonnet is Swing and behind great Pyramid in Egypt.  Some photos of restoring engine.         Old and restored            Next time Gearbox. |
|
| Author: | White 2cv [ October 2nd, 2014, 10:20 pm ] |
| Post subject: | Re: Dyane by White |
Gearbox. Repairing of gearbox, whit a lot of damage outside and inside of box.               
|
|
| Author: | lpgo [ October 2nd, 2014, 10:39 pm ] |
| Post subject: | Re: Dyane by White |
Great pics, gearbox must had a hard time looking at the toothwear... |
|
| Author: | White 2cv [ October 2nd, 2014, 11:01 pm ] |
| Post subject: | Re: Dyane by White |
Gearbox has a lot of different parts inside. Tooth wear, Synchromeshes, bearing, needle bearing, syncro ring itd. And every thing must be perfect for perfect usable gearbox. Easiest think is setting gears. |
|
| Author: | White 2cv [ October 4th, 2014, 7:37 pm ] |
| Post subject: | Re: Dyane by White |
             
|
|
| Author: | White 2cv [ October 5th, 2014, 4:08 pm ] |
| Post subject: | Re: Dyane by White |
             
|
|
| Author: | White 2cv [ October 7th, 2014, 11:31 pm ] |
| Post subject: | Re: Dyane by White |
I have done a half of all sheet metal works until now. My motivation and time are not on my side.  But I have still believe in my self, that welding works gone be finish this month. .....I think so....         
|
|
| Author: | Nelsthebass [ October 7th, 2014, 11:47 pm ] |
| Post subject: | Re: Dyane by White |
What work! I wish I had a fraction of the skill shown here........ |
|
| Page 1 of 3 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|