I've looked at the ones on Roy's website. Can you do a rear one for AK/AZU?: The mounting brackets would need to be stepped somehow, (because the rear panel is lower than the chassis).

For the rear I would like to have a straight one, just as wide as the rear body. Same diameter as the front one.

I'll send you a PM.

Cheers, Rob

re rear bumper for AZU van / AK van
tubing 35 mm dia with a 2 mm wall thickness
all possible , the mounting plates could accomodate
an additional upright bracket to allow it to sit under that rear member
only i would need to know what height you would like it to sit at and what length?
do you go to Poland as it could be a chance to make a basic drawing idea of mounting etc?
or send me a sketch of your requirements.
i will take some stock with me
pony

New production run starts

I too would be interested in this as the rest of an AK/AZU is quite exposed. I'll be in Poland with my 350, happy for it to be measured

I'd be interested in front and rear for my AZU 250. Unfortunately although I will be in Poland, it won't, and the rear of a 250 must be different from a 350.

Currently it has an angle-iron bar ("C" section) bolted to the two loops below the door. I think these were standard PTT fittings, but no doubt someone better informed can put me right.

And I'd love to replace the badly decayed "paperclip" overriders I already have.

Re 250 van rear C section bumpers

I think this C section was fitted By the Belgian post office to do a better job protecting the rear end, as i remember importing s few 3 window AZU 250 vans in the eighties!
I have a 400 van in my yard so will do a bit of checking as to what would be the best route for mounting etc.
but get your thinking cap on as to what you like

and i will bring a few bumpers for local sale in Poland

Any of the front ones made it to the UK yet for sale?

Thanks Roy! It wasn't on the website when I last looked (or I missed it!)