| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| repair panels.. where http://www.international2cvfriends.com/forum/viewtopic.php?f=4&t=4960 |
Page 1 of 1 |
| Author: | db78 [ August 26th, 2013, 7:48 pm ] |
| Post subject: | repair panels.. where |
Ok guys I have a couple of patches required on my project 2cv and would like to fit panels if they are available. whre is the best place to buy repair panels for the floor, scuttle etc? I am based Rushden Northants so in that area a bonus. Many thanks db |
|
| Author: | Sean [ August 26th, 2013, 7:49 pm ] |
| Post subject: | Re: repair panels.. where |
ken when he logs on from being at the national for lower bulkhead and floor - ECAS for all the car shaped bits |
|
| Author: | db78 [ August 26th, 2013, 8:25 pm ] |
| Post subject: | Re: repair panels.. where |
Thanks, ECAS seems to be the place! loads of stuff, Only had to 2cv 2yrs!! haha |
|
| Author: | ayjay [ August 26th, 2013, 9:59 pm ] |
| Post subject: | Re: repair panels.. where |
just bought a complete sill from ecas delivered next day welded it on, no probs exellant product |
|
| Author: | db78 [ August 27th, 2013, 12:14 am ] |
| Post subject: | Re: repair panels.. where |
ayjay wrote: just bought a complete sill from ecas delivered next day welded it on, no probs exellant product Sounds good, had mine up on my ramp tonight for a prod around and not to bad, boot floor needs doing .and a bit near front pass foot well. Want a bonnet in red but think I will just keep looking on eBay ans classifieds etc. Need a bargain. 
|
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|