| International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
| wheel hole dimensions http://www.international2cvfriends.com/forum/viewtopic.php?f=4&t=4030 |
Page 1 of 1 |
| Author: | jack_dyane [ June 17th, 2012, 11:17 pm ] |
| Post subject: | wheel hole dimensions |
Hi guys, does anyone have the measurements for the distance/angle between the wheel stud? If so would you be so kind to tell me what they are. Thanks |
|
| Author: | ken [ June 17th, 2012, 11:35 pm ] |
| Post subject: | Re: wheel hole dimensions |
jack, the correct term is pitch circle diameter (pcd), which is 160mm for A series wheels. Since there are 3 studs, their separation is 120 degrees. If you're looking for alternative wheel rims, the offset of the rim also has to be taken into account. ken jack_dyane wrote: Hi guys, does anyone have the measurements for the distance/angle between the wheel stud? If so would you be so kind to tell me what they are. Thanks |
|
| Author: | jack_dyane [ June 18th, 2012, 7:46 pm ] |
| Post subject: | Re: wheel hole dimensions |
Thank you, not really after alternative wheels, just making a rear hub/drum puller as mine isn't wanting to come off. |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|