Hi .....withoput a pic ...
You have a curved bar at the front [of the shelf] and a straight bar at the back.
The curved bar should have two small screw-holes at [or near] each end .....these holes correspond with two holes in the frame of your rear seat .....[you may find that these are covered with the seat covering material]. Two self tapping screws will secure the front bar.
The rear bar should have two wire clips to secure it onto the metal frame under your rear window .....it just "sorta" hangs on the metal frame with the two clips.
If youre fitting it to a Special,you may find [as I did] that there should be two brackets for the ends of the bar to go into [my rear window/roof did'nt have any] .....so I secured it with two cable ties.
hth .....[if it does'nt,no doubt some-one with a camera will be along shortly,the batteries are flat in mine]
T.
