International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
Transfer box.. A new version... http://www.international2cvfriends.com/forum/viewtopic.php?f=19&t=6468 |
Page 3 of 7 |
Author: | subarupete [ November 25th, 2023, 8:12 pm ] |
Post subject: | Re: Transfer box.. A new version... |
The plan……At the moment the rear cover is removed, the top shaft /longer version/ is replaced and the new “stuff” is bolted on, with output shaft passing under front suspension/steering tube. |
Author: | subarupete [ April 14th, 2024, 12:05 pm ] |
Post subject: | Re: Transfer box.. A new version... |
Now working on the rear diff, while awating some M7 countersunk bolts ? from afar.. So try-out_____ Mounting the Calpers, still quite a lot to fabricate |
Author: | Roger V [ April 14th, 2024, 12:11 pm ] |
Post subject: | Re: Transfer box.. A new version... |
So this is the rear diff, with on board disks? |
Author: | subarupete [ April 14th, 2024, 12:28 pm ] |
Post subject: | Re: Transfer box.. A new version... |
Yes, pretty much all the 4x4 conversions use a standard 2cv gearbox, mounted in the rear,drive is through the standard clutch shaft, 4x4 drive selected via engaging 3rd gear. Did think about outboard discs, not that hard to do mechanicaly. It was done at the front by one of the 2cv race guys, but you need a very slim caliper. Someone sourced them for Willwood? But they would have cost more than I have spent so far on the projectso far.... |
Author: | subarupete [ April 16th, 2024, 12:37 pm ] |
Post subject: | Re: Transfer box.. A new version... |
Need to fabricate/lathe a new Prop flange with a longer tail to fit on the pinion shaft. However the price of Steel has almost doubled !!!! |
Author: | subarupete [ April 16th, 2024, 4:11 pm ] |
Post subject: | Re: Transfer box.. A new version... |
Put off spending, so fit the Calipers at the rear end of the diff.. |
Author: | subarupete [ April 17th, 2024, 4:31 pm ] |
Post subject: | Re: Transfer box.. A new version... |
To make the calipers clear the disc, had to mill 1.5mm of the back of the caliper, more bespoke bits. |
Author: | AZL57 [ April 17th, 2024, 9:57 pm ] |
Post subject: | Re: Transfer box.. A new version... |
Nice job, no connection between left and right to keep the calipers vertical? |
Author: | jasu [ April 18th, 2024, 7:41 am ] |
Post subject: | Re: Transfer box.. A new version... |
AZL57 wrote: Nice job, no connection between left and right to keep the calipers vertical? Not yet, and there will be, I suppose..? |
Page 3 of 7 | All times are UTC + 1 hour [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |