International2cvFriends.com
http://www.international2cvfriends.com/forum/

EPB Refurb
http://www.international2cvfriends.com/forum/viewtopic.php?f=19&t=6413		 Page 4 of 8
Author:  subarupete [ July 10th, 2022, 11:17 am ]
Post subject:  Re: EPB Refurb
Thanks for the info,
Bushes on their way now, but will rummage through to plumbing box, for the next set of spindles.
However the bronze are oil sintered so will outlast me.
Cheers
Peter
Author:  jasu [ July 10th, 2022, 3:05 pm ]
Post subject:  Re: EPB Refurb
Older spindles are much better than later, and easier to service. And on some late spindle, there isn't any bronze bushing, only drilled hole for shaft...

Those linkages are near overkill, but on good way.like them...
Author:  subarupete [ July 10th, 2022, 4:37 pm ]
Post subject:  Re: EPB Refurb
Could have used M4 rose joints, but they are more expensive, they are used on RC planes etc..
Author:  subarupete [ July 30th, 2022, 9:28 am ]
Post subject:  Re: EPB Refurb
Update .. but still lots to do...


LED rear lights.
Attachment:
IMG_0385.jpeg
IMG_0385.jpeg [ 123.81 KiB | Viewed 9167 times ]


Parts on ebay, but cheaper if you use Aliexpress and wait...
https://www.ebay.co.uk/itm/255496392311 ... 0667.m2042





Found the boot stay..
Attachment:
IMG_0389 2.jpeg
IMG_0389 2.jpeg [ 72.63 KiB | Viewed 9167 times ]


Change over fuel tap (under rear seat) for additional fuel tank.
Attachment:
IMG-0376.jpeg
IMG-0376.jpeg [ 86.82 KiB | Viewed 9167 times ]


Craftmaster Under Coat on rear wing (with runs).
Attachment:
IMG_0398.jpeg
IMG_0398.jpeg [ 128.89 KiB | Viewed 9167 times ]


Essential extra Badge.
Attachment:
IMG_0397.jpeg
IMG_0397.jpeg [ 107.89 KiB | Viewed 9167 times ]


Carpet Lining on rear wing.
Attachment:
IMG_0395.jpeg
IMG_0395.jpeg [ 77.49 KiB | Viewed 9167 times ]
Author:  Roger V [ July 30th, 2022, 10:22 am ]
Post subject:  Re: EPB Refurb
That's coming along nicely Pete. :)

I like the idea of the light conversion. :D

Can you still see the lights from anywhere that is not directly behind?
Author:  subarupete [ July 30th, 2022, 2:17 pm ]
Post subject:  Re: EPB Refurb
Bulbs being a point source are the best option. the LED replacments are expensive.
The LED arrays are brigher and the Fresel Lens cover does its job.
See photo
Attachment:
DSC03749.jpeg
DSC03749.jpeg [ 86.6 KiB | Viewed 9160 times ]

Cheers

ps They work under water!
Author:  subarupete [ August 1st, 2022, 12:20 pm ]
Post subject:  Re: EPB Refurb
Can somebody post some pictures of the Rear Door….rubber door seal/metal strip, rivets, nylon and plastic.
Have the parts but what goes on the door and what goes on the pillar???
Thanks in advance..
Author:  subarupete [ August 5th, 2022, 9:12 pm ]
Post subject:  Re: EPB Refurb
Engine and Gearbox ready to refit.

Attachment:
D6405CDA-4753-4927-BFCC-CC50E2CB4FC2.jpeg
D6405CDA-4753-4927-BFCC-CC50E2CB4FC2.jpeg [ 479.7 KiB | Viewed 9075 times ]
Author:  Roger V [ August 5th, 2022, 9:47 pm ]
Post subject:  Re: EPB Refurb
Cool :D

Though have to say I really liked the purple... then realised it was the lifting harness!!
Author:  subarupete [ August 7th, 2022, 3:23 pm ]
Post subject:  Re: EPB Refurb
:D
Page 4 of 8 All times are UTC + 1 hour [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/