International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
EPB Refurb http://www.international2cvfriends.com/forum/viewtopic.php?f=19&t=6413 |
Page 3 of 8 |
Author: | lpgo [ July 1st, 2022, 9:31 am ] |
Post subject: | Re: EPB Refurb |
Looking lovely, why don,t you use Visa haeds and crankcase? |
Author: | subarupete [ July 1st, 2022, 3:39 pm ] |
Post subject: | Re: EPB Refurb |
Had a spare 2cv crankcase, visa’s are not common here. The VGS barrels and pistons are superb quality parts, each machined from a billet, but expensive….. |
Author: | Roger V [ July 2nd, 2022, 11:20 am ] |
Post subject: | Re: EPB Refurb |
i picked up a visa engine the other day, though it's clunking a bit when turning the fan had a spare block and barrels with it, so we will see |
Author: | subarupete [ July 2nd, 2022, 11:45 am ] |
Post subject: | Re: EPB Refurb |
That’s a good find, is the clunk the fan or is it internal? |
Author: | Roger V [ July 2nd, 2022, 7:46 pm ] |
Post subject: | Re: EPB Refurb |
it feels internal. I think the crank has lateral movement. |
Author: | subarupete [ July 8th, 2022, 2:15 pm ] |
Post subject: | Re: EPB Refurb |
Wipers Linkage very tired and rusty. One of the spindles seized. Made some new link arms, 5mm 2cv bolts and 5mm rose joints. Spindles come apart, so clean new o rings and spring washers. |
Author: | rob massey55 [ July 9th, 2022, 9:40 am ] |
Post subject: | Re: EPB Refurb |
Nice! |
Author: | subarupete [ July 9th, 2022, 10:35 am ] |
Post subject: | Re: EPB Refurb |
New spindles are expensive (imported?), bronze bushes, wavy washers and O rings cost approx £20. Refurb can be done in a vice and a few tools… |
Author: | subarupete [ July 9th, 2022, 2:20 pm ] |
Post subject: | Re: EPB Refurb |
Windscreen fitting. Should the gaps be covered with tape or left open?? |
Author: | AZL57 [ July 10th, 2022, 11:05 am ] |
Post subject: | Re: EPB Refurb |
The holes are to let the point welder in, they should be closed with tape to keep water out of the frame. For your bronze bushes in the spindles, it seems some copper water tubes have the perfect size. |
Page 3 of 8 | All times are UTC + 1 hour [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |