International2cvFriends.com http://www.international2cvfriends.com/forum/ |
|
Lockable diff LNA/GS gearbox http://www.international2cvfriends.com/forum/viewtopic.php?f=19&t=4205 |
Page 4 of 4 |
Author: | subarupete [ November 14th, 2014, 12:50 pm ] |
Post subject: | Re: Lockable diff LNA/GS gearbox |
Status so far. Option 1 Working. -------------------------- Using a Xantia "abs block" set valves with switches. Push brake pedal and this will lock the selected wheel or wheels ie diagonals. Downside you need 3 feet , Throttle....Clutch....Brake pedal. Option 2 Plan for after new exhaust and other stuff. ---------------------------------------------------------------------- Using the abs Valves the other way around. New pipe work and 2 into 1 adapters. Push brake pedal and hold, set switches for selected wheels. Wheels are now locked. Option 3 ------------- Arduino micro + code £20 An ABS block with internal pump £20 Bespoke parts for Magnetic Reluctor Rings and sensors. NOT current Slotted kind. £400 Plated Diffs. ------------------ Spoken to a company that make Rally and 4x4 Plated diffs. The GS casing may be just doable at £1200 at a 1 off The 2cv diff...... I need to visit for a closer look but not a NO at the moment. |
Author: | Pony [ November 15th, 2014, 12:01 am ] |
Post subject: | Re: Lockable diff LNA/GS gearbox |
Boys i should inform!! i have already got made by Quaife an additional splined collar (to go onto the diff carrier) similar to my 2cv full lock set up It is 38 mm dia not 35 so much stronger It will bolt direct to the GSA LSD However i have not yet got round to getting the sliding collar and out put shaft into production, although it is all drawn up Actually all in preparation for my new rear diff idea based on Visa and GSA parts again a time money issue! pony |
Page 4 of 4 | All times are UTC + 1 hour [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |